完美世界国际版下载,完美世界有声小说,已完本玄幻小说排行榜

BYD Lithium Battery Warehouse Forklift Forklift Operation Notes-

Check the turn signal; 5

Electric transport truck manufacturers remind everyone that the motor, battery and other important parts of the electric transport truck must be checked regularly They may also have certain failures during use Otherwise, it is very easy to cause safety accidents during subsequent use

Manipulator arm During driving, the electric pallet truck is controlled by the manipulator arm to travel and turn, and the maximum turning angle of the manipulator arm is about 180 degrees

In contrast, BYD Forklift, which started to enter the electric forklift field as early as ten years ago, should not be underestimated in its deep layout in the industry

It is strictly forbidden to use in blind areas; 9

In recent years, the country's warehousing requirements for enterprises have become increasingly stringent

Flexible configuration of the forklift for subsequent use

Understanding the formula for calculating the aisle width of electric hydraulic forklifts can not only help companies make better use of factory buildings and design aisles reasonably and scientifically, but also provide a reference for companies to purchase electric forklifts

Disadvantages: Manual transport trucks rely on human power to pull, which consumes manpower, requires effort when the ground is uneven, and has low transport efficiency

(2) Turn the key switch to the on position

Its implementation principle is basically the same as that of a general electric forklift, but there are obvious differences in design and component selection

BYD Lithium Battery Warehouse Forklift Forklift Operation Notes- It involves a complete set of system matching and technical support Forklift drivers, please note: (1) Before moving the vehicle, make sure there are no people in front, behind, or around the vehicle, especially if there are obstacles around; (2) When driving, do not exceed the speed limit, slow down when turning, and point to confirm; (3) It is strictly prohibited to use shelves, material frames, etc1*1

The new generation of electric forklifts will have better maintainability and operability, and the display and fault diagnosis systems will be more complete

Counterbalanced forklift AGV is mainly used for raw material distribution on production lines, transportation of semi-finished products and finished products, and palletizing in warehouses and docks, replacing manual labor for simple and frequent operations, thereby improving work efficiency

At the same time, due to the heavy weight of the cargo, in order to ensure the rigidity of the telescopic gantry at a high position, this unmanned forklift is designed with a double telescopic gantry Product Introduction: 1 The market sales are increasing year by year (7) When the vehicle is carrying cargo and traveling uphill or downhill at an angle exceeding 7 degrees and at a speed higher than first gear, the brakes must not be used unless in special circumstances In addition, the width of the right-angle stacking channel should also be considered, which means that the electric forklift can safely pass through when turning 90 degrees in the corridor After installation, check whether the screws and elastic pins are installed in place and whether the wheel installation position is correct and not loose Before the unmanned forklift enters the fork, it first uses the sensor to detect the presence of cargo on the shelf and verify the correctness of the lifting height to ensure safe entry; ⑤ The unmanned forklift is equipped with a gyroscope On the basis of primer spraying, the iron plate of the body can be sprayed with a low-temperature rust-resistant protective layer to cope with the huge temperature difference in the storage operation

Electric transport trucks are time-saving, labor-saving, cost-saving, and highly efficient

If it is lower than the standard value, it indicates that the charging voltage is too low

BYD Lithium Battery Warehouse Forklift Forklift Operation Notes- The altitude shall not exceed 1,200 meters The installation sequence is the opposite of the disassembly sequence 4 Speed regulating device It operates normally at 24V voltage and the speed is adjusted by electronic control It also has the advantages of ultra-low noise and ultra-low vibration

When there are obstacles or pedestrians on the route, the vehicle will automatically stop or give way, reducing the bumps and damage associated with handling, ensuring that the materials are transported to the designated location in good condition, and greatly reducing the uncertainty caused by manual forklifts

The operator must understand the condition of the vehicle before using it, and must not allow unsupervised personnel to operate it at will; therefore, when using an electric transport truck, it is necessary to use it in a standard manner, and at the same time it is necessary to pay attention to its protection and maintenance to extend its service life

What are the advantages of electric transport vehicles What are the advantages of electric transport vehicles? 1

■ Easier to operate Equipped with multi-disc parking and service brakes, the machine has better maneuverability

Of course, there are certain differences in prices between different configurations Forklift is a non-manpowered tool for transporting goods in warehouses How to operate a new electric transporter How to use an electric transporter is not difficult, practice makes perfect

国产视频首页-国产视频网-国产视频网站在线-国产视频亚洲-日韩欧美精品一区二区三区-日韩欧美区

New energy forklift leader

Product

BYD Counterbalanced forklift

BYD Warehouse Forklift

BYD large tonnage forklift

BYD tractor truck

Core Features

High security

high performance

High efficiency

High Match

Low overall cost

Super fast charging

Ultra-long life

No charging room required

About Us

Product

BYD Forklift

Contact Info